Home / Coffee Knowledge / ECM Synchronika I and II in Test
    Dualboiler
    ECM Synchronika I und II im Test

    ECM Synchronika I and II in Test

    The ECM Synchronika is a dual boiler espresso machine from the German company ECM. We tested the Synchronika 1 and in 2024 the Synchronika 2. In this article you will find our compiled results for both models, temperature curves as well as our video reports.

    If you have gathered your own experiences with the ECM Synchronika, we would be happy to hear your comments. This supplements our test and helps other interested parties get a more comprehensive picture of the machine in everyday use. Thank you!

    Since the ECM Synchronika I will continue to be sold for a while longer, we will keep the information about this machine as it is. All information that applies exclusively to the ECM Synchronika II can be found further down in the article: Jump to the new ECM Synchronika II

    General Information and Facts

    The ECM Synchronika is an espresso machine of enormous scope, weight, material quality and value retention. This machine was built to stand the test of time. All components radiate this.

    We measure a width of 33.5 cm, a height of 41 cm without cups and with our own cups a height of 45 cm. This can be interesting for you if the machine is to stand under a low wall cabinet in the kitchen. The ECM Synchronika is already 48.5 cm deep in its base. With the portafilter inserted, the Synchronika reaches a depth of 59 cm. This makes the machine a considerable weight of 30 kilograms.

    size ecm synchronika

    The ECM Synchronika has a high-gloss polished stainless steel housing. It looks beautiful, reflects wonderfully and unfortunately collects numerous fingerprints. The polishing cloth will need a permanent place near the espresso machine.

    The Synchronika is equipped with a 2 liter steam boiler and a 0.75 liter brew boiler. The rotary pump is very quiet and purrs like a kitten during extraction. We measure the remarkably low value of only 59.2 decibels. We read from the community that in some cases the machine rattles much louder. We identified such rattling and sliding in the drip tray, but this can be bridged with magnets or rubber holders.

    The rotary pump, in turn, allows us to connect the machine to mains water. A drain hose can also be attached to the drip tray. We fill it with a maximum of 850 ml if it is not connected to the drain and if we still want to carry it to the sink.

    The water tank holds 2.5 liters, can be removed via a flap from the top and is of high-quality workmanship. Water is supplied via a valve in the bottom.

    handles ecm synchronika

    Package Contents

    The ECM Synchronika is one of the espresso machines that comes with a good accessory set that really makes sense. Sometimes manufacturers go overboard with accessory items that then have inferior quality. The ECM Synchronika comes with two beautiful, heavy portafilters that are perfectly balanced and have an appearance that fits very well with the Synchronika.

    Like the lever handles, they have a trapezoidal tip made of polished stainless steel, topped with a black hard plastic setting. A perfectly fitted heavy tamper with a finger-width base is a noble tool that does ECM great honor.

    Also included is a cup stand that elevates the espresso cups and ensures that the pours always hit the cups. The stand is nevertheless designed so that a scale can fit both on it and next to it.

    Anyone wishing to connect the ECM Synchronika to mains water will find the connection hose already in the package contents.

    side view synchronika

    Temperature Curves

    Once the ECM Synchronika has reached its thermal equilibrium, it is a relatively temperature-stable espresso machine. However, it takes... We waited 35 minutes until the Synchronika reached a brew temperature of 93 degrees with all important components. The boiler certainly reaches temperature much earlier. However, the E61 brew group and portafilter are so heavy that this amount of time is needed to truly reach temperature.

    The following chart shows in orange a warm-up phase of the ECM Synchronika. After 25 minutes we made the first extractions, one per minute. By the 4th extraction, we had reached the target temperature of 92 degrees with the portafilter. The next chart also illustrates this well.

    After 35 minutes we were nearly at the target temperature with the gray curve, which in this case was 93 degrees (shown in yellow as a bar with +/- 1 degree at 93 degrees). Here too, a flush shot is necessary, which heats the portafilter well, which is not sufficiently heated on its own even after 35 minutes (see also Chart 3.)

    ECM Synchronika Temperatures
    92 degrees 25 min 93 degrees

    The WBC protocol shown in the first chart begins after one hour and then simulates various inactivity intervals. The temperature curves make it clear that the ECM Synchronika reaches temperature very quickly during extraction and achieves the target temperature after 7 to 8 seconds. It then runs very consistently. The consistency during extraction is extraordinarily good.

    However, the machine drifts slightly upward in temperature at a cycle of 1 minute and becomes increasingly warmer. This is a typical problem with Faema E61 espresso machines and is also the case with the Synchronika. The target temperature is therefore not really reliable. Home baristas must get to know their machine very well in order to estimate at which temperature they are currently brewing.

    wbc comparison

    Espresso Quality with the ECM Synchronika

    The ECM Synchronika has everything a good espresso machine needs. It has high temperature stability during extraction, is well made and relies on a first-class rotary pump. Nevertheless, there remains some uncertainty about how much time it takes for the machine to reach which temperature. The ECM Synchronika shares this problem with all Faema E61 espresso machines and the Synchronika offers no solution for it either.

    We have drunk very good espressos, both those with a stronger structure and complex specialty coffees. The Synchronika delivers what it takes with sufficient warm-up time. However, with shorter warm-up times or under frequent use, there are also outlier espressos.

    Energy Consumption

    The long warm-up time is needed to bring the large boilers up to temperature. Of course, this also has consequences for energy consumption.

    We measure 0.43 kilowatt hours after a 25-minute warm-up time and the extraction of 5 double shots. This corresponds to our standardized protocol, which we apply to all machines. It should be noted that we would have had to wait another 10 minutes to measure the machine at full temperature. We will provide this measurement later. The result will likely be somewhat higher. But even so, this is a high value for dual boiler espresso machines. Some thermoblocks get by with less than a quarter for the same amount of espresso extraction.

    ECM Synchronika Power measurement in watts with steam

    Steaming and Milk

    Steaming with the ECM Synchronika is a breeze. The machine provides good power with its 2-liter steam boiler to get the milk completely moving. At the same time, the milk is not heated too quickly, which allows for a pleasant rolling phase. This makes the ECM Synchronika a good hybrid machine for households that value both good espresso and milk-based drinks like cappuccino or flat white.

    ecm synchronika

    Conclusion on the ECM Synchronika I

    The ECM Synchronika is certainly a wonderful machine. It makes good espressos and foams fine-pored milk foam for cappuccino and the like. But the test also leaves me perplexed. Despite all appreciation for the manufacturer and the local specialist dealer network - to me, the machine seems outdated. The Faema E61 brew group recently celebrated its 60th birthday. The guarantee of durability is also a symbol of inertia and is rarely found in combination with real innovation. This is evident in the long warm-up time and the high power consumption. If you are looking for volumetric shot control or programmable pre-infusion, you are looking in vain at the ECM Synchronika.

    Anyone concluding that the high energy consumption means a poor eco-balance for the machine does not factor in the robustness and longevity of the machine in their calculations. The aforementioned specialist dealer network has repaired the Synchronika and similar machines for the last 50 years and will continue to do so for the next 50 years. Therefore, an investment in the ECM Synchronika should also be seen as a long-term investment. If you care for your Synchronika, you will probably never buy another machine in your lifetime.

    So who is the ECM Synchronika the right machine for? Perhaps for you, if you desire durability and longevity. If you don't want to overwhelm yourself with numerous setting options, but instead wish for a high-quality, very good espresso machine from a German manufacturer that will accompany you for a very long time.

    Specialist Dealers We Recommend

    We search for specialist partners for you whom we know provide good work and good service. We are in close contact with the dealers. These are affiliate links. If you order through this link, it won't cost you more, but we receive a small commission that we invest in new test equipment.


    heating elements synchronika 2

    Update: New ECM Synchronika II Unveiled

    At the end of June 2024, ECM presented the new Synchronika 2 at the World of Coffee in Copenhagen. Compared to the Synchronika 1, there is an update that is revolutionary for the espresso machine type with Faema E61 brew group and makes the Synchronika II the fastest heating-up espresso machine with E61 brew group. Two heating cartridges with 200 watts of power each are installed in the brew group. These are actively heated until the warm-up time is reached, thus significantly accelerating the warm-up time of the espresso machine. We measure a warm-up time of 8 minutes! This is the fastest value we have ever measured with an E61 brew group. The previously fastest modified E61 brew group we measured comes from Sanremo and was used in the You. Here the warm-up time was 15 minutes. By the way, the steam boiler is not at full capacity after 8 minutes. You'll need to wait a few more minutes for that.

    ECM Synchronika 1

    Temperature Curve After 8 Minutes Very Good!

    After the 8-minute warm-up time, the ECM Synchronika II shows very good temperature performance. We measure a standard deviation over 5 extractions of only 0.63° Celsius. In the first extraction, we measure a maximum temperature difference of 1.7° Celsius between second 5 and 25 of the extraction. Over all 5 extractions, we reach a value of 2.15° Celsius, with the temperature average value at the set temperature of 93° Celsius at 92.63°.

    After an extended period of machine inactivity, we also observe rising temperature with the ECM Synchronika 2, typical for espresso machines with Faema E61 brew group.

    Power measurement

    Power Measurement and Energy Consumption of the Synchronika II

    Of course, the fast warm-up time also has major impacts on energy consumption. Especially when we leave out the steam boiler, we measure for 5 extractions a consumption including warm-up of only 0.17 kWh. Through the rapid warm-up we save electricity on one hand, on the other hand the two heating rods of course consume electricity. Nevertheless, the value for a dual boiler of this magnitude is a good value. If we additionally turn on the steam boiler, the energy consumption for 5 extractions is 0.31 kWh, which is still a good value for a dual boiler. Bravo ECM!

    Buy ECM Synchronika

    The following specialty shops* carry the ECM Synchronika and we can recommend purchases from these businesses.

    Switzerland: [Partner links] Simons Kaffee

      Comments

      Welche Maschine sollen wir noch testen?

      Espressomaschine oder Mühle: Sag uns, was als Nächstes auf unseren Testtisch soll. Wir lesen jeden Wunsch.

      Deine E-Mail nutzen wir nur für Rückfragen zu deinem Wunsch. Den Newsletter bekommst du nur, wenn du ihn ankreuzt und bestätigst. Datenschutzerklärung